DIgSILENT Ibérica DIgSILENT Ibérica - Power System Engineering and Software
Slide 1 Slide 1 Slide 1 Slide 1
  • Change language
    Select language

CIGRE B4.57 DC Grid Test System - Part II: Average-value models (TYPE 5) DCS1 test system in DIgSILENT PowerFactory
| | | | | |

Publicado el 5 de Abril de 2018

DIgSILENT Ibérica, in collaboration with the Universidad Carlos III de Madrid, released last June 2016 the first draft of the DC Grid Test System model, intended for steady-state studies (load flow, contingency, short-circuit calculations, power quality studies, etc.). Today DIgSILENT Ibérica is launching the second part of the DC Grid Test System model.

The CIGRE proposal is based on three different cases: “DCS1”, “DCS2” and “Full Test System”. In the published paper, the model corresponding to topology “DCS1” has been upgraded with the implementation of the control and protection system dynamic models in DIgSILENT PowerFactory. The implemented models are corresponding to the Average Value models (Type 5) described by CIGRE. This paper is a continuation of earlier and preliminary work where the model and results of the steady state implementation were covered.

All dynamic models and their parameters are described and detailed throughout the paper. Results of the dynamic studies are given, and time-varying signals are presented in plots as a guide for final users. The complete description and model parameters can be found in the following link to the published papers and articles section: CIGRE DC Test System Part II: Average-value models (TYPE 5) DCS1 test system in DIgSILENT PowerFactory

Do not hesitate to contact us by sending an email to info@digsilentiberica.es if you are interested in getting the PowerFactory project in pfd format, version 2018 SP1.


Thank you for your sharing!

Etiquetas: HVDC, MMC, DCS1, Benchmark, CIGRE, DC Grid Test System, EMT